Available Sheens: Primer
Available Colours: White, Red, and Gray
Colorant Used: N/A
Colour System Supported: N/A
Cleanup: Xylene
Resin Type: Phenolic Alkyd
Recommended Use: Exterior and interior
MPI Rating: N/A
VOC Level: 393 g/L
Waterborne Bonding Primer
Related products
-
Prep All Universal Metal Primer
V132
Show DetailsPrep All Universal Metal Primer is an economical, single-component primer engineered to provide corrosion protection on all ferrous metals. This quick-drying formula provides fast production times, and its alkyd resin formulation allows for application of a wide variety of intermediate and finish coat products. Formulated for air spraying, it can also be applied by airless and HVLP sprayers, brushes, or rollers.
- Fast 30 minute dry – recoat in 4 hours
- Tie coat over many existing coatings
- Corrosion protection on all ferrous metals
- Available in White, Red or Gray
-
100% Solids Epoxy Pre-Primer
V155
Show Details100% Solids Epoxy Pre-Primer is formulated for use on both steel and masonry. For rusted steel where extensive surface preparation is needed, but not logistically possible, the penetrating properties and extended dry time – 16 hours at 25 °C (77 °F) – of this two-component epoxy seal crevices and other imperfections, promoting better adhesion for subsequent coats. For prepared masonry surfaces, V155 penetrates and seals, providing an excellent foundation for subsequent coats of Corotech epoxy floor coatings. The unique, 100% solids formula of V155 forms a sealed epoxy barrier that inhibits future corrosion.
- Low viscosity easily fills voids and crevices
- Does not shrink – eliminates craters
- Chemical and fume resistant
- Extended cure time allows maximum penetration
- Seals previously coated concrete, masonry, and galvanized metal
- Qualifies for LEED certification
-
Acrylic Metal Primer
V110
Show DetailsAcrylic Metal Primer is a water-reducible, rust-inhibitive primer for steel, iron, and non-ferrous metal. It provides excellent adhesion to a range of hard-to-coat surfaces and can even be applied over tightly adhering rust. Designed for light-to-moderate industrial exposures, this product can be top coated with a wide variety of coatings.
- High solids content
- Low odour; suitable for occupied areas
- Can be recoated in just 4 hours
- Suitable for use in USDA-inspected facilities
- Qualifies for LEED certification
-
100% Solids Epoxy Floor Coating
V430
Show DetailsHeavy-duty protection from a 100% solids epoxy for demanding industrial/commercial environments exposed to heavy vehicular and pedestrian traffic, constant moisture, intermittent strong chemical spills, and frequent cleaning with chemicals, steam and power washers.
- Self-levelling, high-build 100% solids formula
- Very low VOC
- Tenacious adhesion to concrete
- Outstanding durability
- Smooth gloss finish
- Meets qualifications for LEED as a floor coating
- Suitable for use in USDA inspected facilities
Reviews
There are no reviews yet.