Available Sheens: Primer
Available Colours: Red and Gray
Colorant Used: N/A
Colour System Supported: N/A
Cleanup: Mineral Spirits or High Flash Naphtha
Resin Type: Alkyd
Recommended Use: Interior or exterior
MPI Rating: N/A
VOC Level: 337 g/L
Prep All Universal Metal Primer
Related products
-
Shop Primer
V142
Show DetailsShop Primer is an economical steel primer for commercial use in mild to moderate exposures. This product is ideal as a temporary transport coat on fabricated pieces or as an economical barrier primer. It is a temporary coating. This primer may be top-coated with a wide variety of finishes. However, finishes containing strong solvents (Ketones, Xylene, Toluene) may cause wrinkling or lifting of Shop Primer.
- Economical protective coat
- Accepts a wide variety of topcoats
- Dry to the touch in 30 minutes
-
100% Solids Epoxy Pre-Primer
V155
Show Details100% Solids Epoxy Pre-Primer is formulated for use on both steel and masonry. For rusted steel where extensive surface preparation is needed, but not logistically possible, the penetrating properties and extended dry time – 16 hours at 25 °C (77 °F) – of this two-component epoxy seal crevices and other imperfections, promoting better adhesion for subsequent coats. For prepared masonry surfaces, V155 penetrates and seals, providing an excellent foundation for subsequent coats of Corotech epoxy floor coatings. The unique, 100% solids formula of V155 forms a sealed epoxy barrier that inhibits future corrosion.
- Low viscosity easily fills voids and crevices
- Does not shrink – eliminates craters
- Chemical and fume resistant
- Extended cure time allows maximum penetration
- Seals previously coated concrete, masonry, and galvanized metal
- Qualifies for LEED certification
-
Coal Tar Epoxy
V157
Show DetailsCoal Tar Epoxy is a high-solids, two-component tar filled coating formulated to provide excellent film build in one or two coats. The high level of cross-linking provides an excellent barrier coat for immersion service in fresh water, salt water or waste water. Additionally, this product is resistant to many acids, alkalis and mild solvents in splash and spill exposures.
- Formulated for use over properly prepared/primed steel, iron, concrete, and non-ferrous metal
- Provides excellent protection from water, acids, alkalis, and mild solvents
- Can be applied directly to the substrate; use with a primer for extra longevity
- Suitable for use in USDA inspected facilities
- Meets Performance Requirements for Army Corps of Engineers C-200
- Meets Performance Requirements for SSPC Paint 16
- Meets Performance Requirements for DOD-P-23236
-
Acrylic DTM Enamel – Gloss
V330
Show DetailsAcrylic DTM Enamel delivers superior resistance to moisture. This waterborne, all-acrylic finish can be applied direct-to-metal or over primer. The glossy surface is UV resistant, and special inhibitors in the formula prevent flash rusting when the finish is applied to ferrous metal.
- For light-to-moderate industrial exposures
- For metal, wood and masonry substrates
- Flash rust resistant and corrosion protection on ferrous metals
- Excellent for all corrugated metal sheeting
- Meets Performance Requirements of TT-P-1511
Reviews
There are no reviews yet.