Available Sheens: Low-gloss
Available colours: Clear
Colorant Used: N/A
Colour System Supported: N/A
Cleanup: Soap and water
Resin Type: Acrylic
Recommended use: Interior/Exterior
MPI Rating: N/A
VOC level: 164 g/L
Rust Arrestor
Related products
-
Clear Acrylic Sealer
V027
Show DetailsClear Acrylic Sealer is a waterborne, fast drying, clear acrylic coating formulated as an easy-to-apply seal coat on bare concrete floors and other masonry surfaces. This product is designed to allow for easy sweep up of dust and to reduce water penetration or erosion, efflorescence, spalling, and chalking without changing the natural appearance of the substrate. Areas exposed to heavy-duty industrial traffic or severe exterior conditions may require multiple coats.
- Rapid dry
- Soap and water clean-up
- Can be used over a variety of substrates
- Blister and alkali fume resistant
- Low odour
-
100% Solids Epoxy Pre-Primer
V155
Show Details100% Solids Epoxy Pre-Primer is formulated for use on both steel and masonry. For rusted steel where extensive surface preparation is needed, but not logistically possible, the penetrating properties and extended dry time – 16 hours at 25 °C (77 °F) – of this two-component epoxy seal crevices and other imperfections, promoting better adhesion for subsequent coats. For prepared masonry surfaces, V155 penetrates and seals, providing an excellent foundation for subsequent coats of Corotech epoxy floor coatings. The unique, 100% solids formula of V155 forms a sealed epoxy barrier that inhibits future corrosion.
- Low viscosity easily fills voids and crevices
- Does not shrink – eliminates craters
- Chemical and fume resistant
- Extended cure time allows maximum penetration
- Seals previously coated concrete, masonry, and galvanized metal
- Qualifies for LEED certification
-
Pre-Catalyzed Waterborne Wall Epoxy — Eggshell
V342
Show DetailsThis unique product provides epoxy toughness in a ready-to-use waterborne formula for walls, ceilings and trim (not ideal for floors). Low odour, low VOC and water cleanup make this product ideal for use in occupied areas. The cured film is scrubbable, resists water and common cleaning chemicals, and stands up to abrasion and marring. Excellent adhesion to many surfaces, including existing paint, drywall, primed masonry and primed metal.
- Single pack – no catalyst
- Tints to all colours
- Qualifies for LEED
- Excellent for retail, commercial, healthcare, schools and more
- Low odour, low VOC and water cleanup
-
Waterborne Amine Epoxy
V440
Show DetailsWaterborne Amine Epoxy is formulated to provide good chemical, abrasion and impact resistance on a variety of commercial and industrial surfaces, including steel, iron, concrete, non-ferrous metals, wood and drywall. Particularly suited for use on concrete floors. This waterborne product has lower odour than solvent based epoxies, is easy to apply, and thus can be applied in occupied areas. Additionally, this product can be applied to many existing generic coating types with less risk of lifting or wrinkling.
When used on floors, this product provides moderate- to heavy-duty protection in commercial environments exposed to frequent foot traffic and occasional traffic of lightweight rubber-tired vehicles, intermittent spillage of mild chemicals, occasional steam cleaning, and powerwashing.
- Water cleanup, low odour, fast dry
- Easy application with excellent adhesion
- Very good resistance to water and chemicals
- Excellent for use on basement floors
- Meets qualifications for LEED when used over metal substrates
- Suitable for use in USDA inspected facilities
Reviews
There are no reviews yet.