Available Sheens: Primer
Available Colours: Red and Gray
Colorant Used: N/A
Colour System Supported: N/A
Cleanup: Epoxy Thinner
Resin Type: Polyamide Epoxy
Recommended Use: Interior or exterior
MPI Rating: N/A
VOC Level: 322 g/L
Alkyd Gloss and Hardness Catalyst
Related products
-
Polyamide Epoxy Primer
V150
Show DetailsPolyamide Epoxy Primer is formulated for use on ferrous and non-ferrous metals in industrial and commercial applications. This two-component, rust-inhibitive epoxy primer is an excellent choice for use as a rust-inhibitive base coat when used as part of a high-performance coating system. With proper top coating, it demonstrates excellent resistance to moisture and chemicals, including solvents, acids, and alkalis. Polyamide Epoxy Primer is also suitable for use on concrete substrates in secondary containment and immersion service applications.
- High-solids content
- Outstanding protection against corrosion
- Engineered for use in general metal finishing and fabrication
- Also appropriate for chemical processing facilities and transportation infrastructure finishing
- Suitable as a high-performance tie coat; especially over existing epoxies
- Suitable for use in USDA-inspected facilities
-
Organic Zinc Rich Primer
Show DetailsShop Primer is an economical steel primer for commercial use in mild to moderate exposures. This product is ideal as a temporary transport coat on fabricated pieces or as an economical barrier primer. It is a temporary coating. This primer may be top-coated with a wide variety of finishes. However, finishes containing strong solvents (Ketones, Xylene, Toluene) may cause wrinkling or lifting of Shop Primer.
- Economical protective coat
- Accepts a wide variety of topcoats
- Dry to the touch in 30 minutes
-
Clear Acrylic Sealer
V027
Show DetailsClear Acrylic Sealer is a waterborne, fast drying, clear acrylic coating formulated as an easy-to-apply seal coat on bare concrete floors and other masonry surfaces. This product is designed to allow for easy sweep up of dust and to reduce water penetration or erosion, efflorescence, spalling, and chalking without changing the natural appearance of the substrate. Areas exposed to heavy-duty industrial traffic or severe exterior conditions may require multiple coats.
- Rapid dry
- Soap and water clean-up
- Can be used over a variety of substrates
- Blister and alkali fume resistant
- Low odour
-
100% Solids Epoxy Pre-Primer
V155
Show Details100% Solids Epoxy Pre-Primer is formulated for use on both steel and masonry. For rusted steel where extensive surface preparation is needed, but not logistically possible, the penetrating properties and extended dry time – 16 hours at 25 °C (77 °F) – of this two-component epoxy seal crevices and other imperfections, promoting better adhesion for subsequent coats. For prepared masonry surfaces, V155 penetrates and seals, providing an excellent foundation for subsequent coats of Corotech epoxy floor coatings. The unique, 100% solids formula of V155 forms a sealed epoxy barrier that inhibits future corrosion.
- Low viscosity easily fills voids and crevices
- Does not shrink – eliminates craters
- Chemical and fume resistant
- Extended cure time allows maximum penetration
- Seals previously coated concrete, masonry, and galvanized metal
- Qualifies for LEED certification
Reviews
There are no reviews yet.